Revision history After publication of this service manual, the parts and mechanism may be subject to change for improvement of their performance. Therefore, the descriptions given in this service manual may not coincide with the actual machine. When any change has been made to the descriptions in the service manual, a revised version will be issued with a revision mark added as required.
Field Service Ver. 1.0 Jan. 2009 1. PRODUCT SPECIFICATION OUTLINE PRODUCT SPECIFICATION A. Type Name Punch unit Type FS-integrated type punching operation device B. Functions Punching method Stops and punches every paper No. of holes 2-3 holes / 2-4 holes / 4 holes 2 holes / 8.0 mm / 70 mm pitch - 3 holes 6.5 mm / 108 mm pitch...
Page 7
1. PRODUCT SPECIFICATION Field Service Ver. 1.0 Jan. 2009 Blank Page Service Manual Y110630-3...
Field Service Ver. 1.0 Jan. 2009 2. PERIODICAL MAINTENANCE PROCEDURE MAINTENANCE PERIODICAL MAINTENANCE PROCEDURE • Periodically replaced parts are not employed. Y110630-3 Sevice Manual...
3. OTHER MAINTENANCE ITEM Field Service Ver. 1.0 Jan. 2009 OTHER MAINTENANCE ITEM Disassembly/Adjustment prohibited items A. Paint-locked screws NOTE • To prevent loose screws, a screw lock in blue or green series color is applied to the screws. • The screw lock is applied to the screws that may get loose due to the vibrations and loads created by the use of machine or due to the vibrations created during transportation.
Field Service Ver. 1.0 Jan. 2009 3. OTHER MAINTENANCE ITEM Disassembly/reassembly parts list Section Part name Ref. page Unit Punch kit Punch oscillating motor (M302) Others Punch drive motor (M301) Disassembly/reassembly procedure 3.3.1 Punch kit 1. Remove the finisher from the main body. 2.
Page 11
3. OTHER MAINTENANCE ITEM Field Service Ver. 1.0 Jan. 2009 5. Disconnect three connectors [1]. A11TF2C503DA 6. Remove the harness from five wire saddles [1]. A11TF2C504DA 7. Disconnect the connector [1] from the motor. 8. Remove the harness from the wire saddle [2].
Page 12
Field Service Ver. 1.0 Jan. 2009 3. OTHER MAINTENANCE ITEM 9. Disconnect the connector [1] of the sensor. 10. Remove the harness from four wire saddles [2] and two edge covers [3]. A11TF2C506DA 11. Remove four screws [1]. A11TF2C507DA 12. Pull the punch kit [1] out and remove it from the finisher.
3. OTHER MAINTENANCE ITEM Field Service Ver. 1.0 Jan. 2009 3.3.2 Punch oscillating motor (M302) 1. Remove the punch kit. See P.5 2. Remove two screws [1], and remove the punch oscillating motor [2]. A11TF2C001DA 3. Reinstall the above parts following the removal steps in reverse. 3.3.3 Punch drive motor (M301) 1.
Page 14
Field Service Ver. 1.0 Jan. 2009 3. OTHER MAINTENANCE ITEM 5. Remove two screws [1], and remove the punch drive motor [2]. A11TF2C004DA 6. Reinstall the above parts following the removal steps in reverse. Y110630-3 Sevice Manual...
Page 15
3. OTHER MAINTENANCE ITEM Field Service Ver. 1.0 Jan. 2009 Blank Page Service Manual Y110630-3...
Page 16
UPDATING STATUS DATE UPDATED PAGES PAGES CODE 03/2009 EDITION Y110630-3...