Table of Contents
Advertisement
Battery Charger
This section explains how to choose a location for the battery charger and install it. It also
explains how to insert and remove a battery pack.
Positioning the Battery Charger
The battery charger can be placed on a desk, or it can be mounted on a wall. Before you
install the battery charger, note the following considerations:
Locate the battery charger within 5 feet (1.6 m) of either side of (and for wall or shelf
mounting, within 5 feet (1.6 m) above) a properly grounded 3-prong electrical outlet
that is not controlled by an on/off switch.
If your communications system uses an uninterruptable power supply, such as a
backup generator, be sure to connect the battery charger to that power supply.
Do not locate the battery charger where it will be exposed to direct sunlight or water.
WARNING:
The Rechargeable battery contains nickel and cadmium. Do not burn or puncture
the battery. Like other batteries of this type, if it is burned or punctured, it could
release toxic material which could cause injury. Do not dispose of it in household
garbage. For information about recycling or proper disposal, consult your local
solid waste (garbage) collection or disposal organization.
Installing the Battery Charger
If you are wall mounting the battery charger, follow Steps 1 through 9
If you are desk mounting the battery charger, follow only Steps 1, 4, 5, and 9
Check to make sure the battery charger's power
1
cord is unplugged from the wall outlet before
continuing. If you are desk mounting, skip to Step 4.
To wall mount, gently place the battery charger
2
upside down. Push in the wide end of the
mounting base (1) and lift upwards (2) to separate the
base from the battery charger.
2-26
Installing the MDW 9010
Wall Mounting Only
Advertisement
Table of Contents
