Table of Contents
Advertisement
Problem
The subject is not
in focus
The flash does not
discharge
The USB
connection with a
personal computer
does not function
properly
The USB
connection with a
printer does not
function properly
8
Very occasionally, static electricity may cause camera malfunction. In
this case, remove the batteries and install them again. If the camera is
then working properly, normal condition is restored and you can continue
using the camera.
202
Cause
The subject is difficult
to focus on with
autofocus
The subject is not in
the focusing area
The flash mode is set
to a (flash off)
The drive mode is set
to j
The focus mode is set
to s
The shooting mode is
set to C
The USB connection
setting of the camera
is set to [PictBridge]
The USB connection
setting of the camera
is set to [PC]
Remedy
The camera may have difficulty in
focusing on such subjects as: low
contrast subjects (a white wall, a blue
sky, etc.), dark subjects, finely-patterned
objects, rapidly-moving objects. It is also
difficult to get proper focus when
shooting through a window or a net. Try
shooting using the focus lock (p.61).
Locate the desired subject in the focus
frame (focusing area) in the center of the
display. If it is difficult to do so, first lock
the focus on the desired subject (focus
lock), and then move the camera to
recompose.
Set to Auto or b (Flash On) (p.89).
The flash does not discharge in these
modes.
Set the USB connection setting to [PC]
(p.165).
Set the USB connection setting to
[PictBridge] (p.165).
Advertisement
Table of Contents
