Manual Focusing; Using The Focus Indicator - Pentax MZ-6 Operating Manual

MZ-6(E)04 D2/074-084 11/8/02 12:04 PM
Memo Memo Using the snap-in focus function
When the subject comes to the point where the lens was pre-focused, the
shutter is automatically released.
qUse a non-autofocus lens.
wSet the focus mode switch to [AF].
eFocus at the point where you wish to capture the subject.
rUsing optional cable switch, keep the trigger button pressed so that the
autofocus and metering systems stay active.
The shutter will be released automatically when the subject comes into
focus at the point selected.

MANUAL FOCUSING

When you focus manually, you can either look at the focus
indicator [ ] or the viewfinder's matte field to check if the
subject is in focus.
N Using the focus indicator [
Memo Memo
If the maximum aperture of the attached lens is f/5.6 or larger (f/1.2 -
f/5.6), you can use the focus indicator [
With slower lenses, adjust a focus on the matte screen in the viewfinder.
1
Setting manual focus (MF)
qSet the focus mode switch to [MF].
78
Page 78
]
] as a guide to achieve focus.
2
Focusing
qFrame the subject, then press the
shutter release button halfway down.
wTurn the focusing ring on the lens
until the subject is in focus.
When focus is achieved, the focus indi-
cator [ ] lights and the audible PCV
signal beeps.
eCheck that the focus indicator [
is lit, then press the shutter release
button completely.
N Using the viewfinder's matte screen.
1
Setting manual focus (MF)
qSet the focus mode switch to [MF].
2
Focus the subject
qFrame the subject, then turn the
focusing ring on the lens until the
subject is in focus.
Focus until the subject looks sharp in
the viewfinder.
wCheck that the subject is in sharp
focus, then depress the shutter
release button completely.
ABOUT FOCUSING
]
79