Self-Timer Mode - Pentax MZ-6 Operating Manual

MZ-6(E)04 D1/045-073 11/8/02 12:00 PM
1
Setting the multi-exposure mode
q Turn the main switch to ON.
wPress the drive mode button until [
appears on the LCD panel.
The frame counter will blink.
2
Using the multi-exposure mode
q Take the first picture.
The frame counter and [
LCD panel blink.
w Take the second picture.
The frame counter stops blinking
and film is advanced to next frame
then return to single frame drive
mode [ ].
Memo
Memo
To exposed the third shot or more,
press the drive button until [
appears after repeating step 1.
Memo Memo
The multi-exposure mode remains in
effect even after the main switch is
turned [OFF]. To cancel the multi-expo-
sure mode, remove the batteries once
and load again.
48
Page 48
]
] on the
]

SELF-TIMER MODE

After you pressing the shutter release button, the picture
will be taken about 12 sec. later. Use the self-timer when
you want to be in the picture.
1
Setting the self-timer mode
qTurn the main switch to ON.
wPress the drive mode button until [
appears on the LCD panel.
Memo Memo Preventing stray light from entering the eyepiece
Underexposure may occur if light enters the viewfinder during self-timer
operation on auto picture mode and 6 picture modes. If you intend to
move away from the viewfinder, attach the supplied finder cap or use
AE lock function ( p.73).
Detaching Eyecup Attaching the finder cap
2
Using the self-timer mode
qDepress the shutter release button
halfway down to focus the subject.
CAMERA OPERATION
]
49