System Initialisation; Entering The Security Code; Acquiring Gps Information - Acura ILX 2013 Owner's Manual

System Initialisation

The navigation system must be initialised if
power to the navigation system is
interrupted for any reason (e.g., the
battery was disconnected).

Entering the Security Code

Find the navigation system's security code
and serial number label in your Owner's
Manual kit. Do not store the label in your
vehicle. If you lose the label, you must first
retrieve the serial number, and then obtain
the code. You can find out about your
serial number and security code from a
dealer.
206
Index
1. Set the power mode to ON, and turn on
the audio system.
If you set the power mode to
ACCESSORY, you will be requested
to enter the security code. See step 3.
2. Press and hold the VOL 9 (Volume/
Power) button for more than two
seconds.
The system is reactivated when the
system's control unit recognizes that
the system is in your vehicle.
If the control unit fails to recognize,
"ENTER CODE" appears on the
navigation screen.
3. Enter the security code.
If you do not enter the security code
correctly after 10 tries, leave the
system for one hour before trying
again, or visit a dealer to have the
system reset.
Table of contents

Acquiring GPS Information

Depending on the length of time the
power was interrupted, your system may
require GPS initialisation.
If initialisation is not necessary, the system
proceeds directly to the Startup
Confirmation screen.
If the system fails to locate a sufficient
number of satellites to locate your position
within 10 minutes, the following screen is
displayed.