Ford taurus 2013 Owner's Manual page 172

Hide thumbs Also See for taurus 2013:

Table of Contents

172 Universal Garage Door Opener (If Equipped)

For questions or comments, please contact HomeLink at

www.homelink.com or 1-800-355-3515.

Erasing the Function Button Codes

Reprogramming a single button

To program a device to a previously trained button, follow these steps:

1. Press and hold the desired button. Do NOT release the button.

2. The indicator light will begin to flash after 20 seconds. Without

releasing the button, follow Step 1 in the Programming section.

For questions or comments, contact HomeLink at www.homelink.com or

1-800-355-3515.

Programming HomeLink to a Genie Intellicode 2 garage door

Note: The Genie Intellicode 2 transmitter must already be programmed

to operate with the garage door opener.

Programing the transmitters

To program HomeLink to the transmitter you must first put the

transmitter into programming mode. To do this

Owners Guide gf, 2nd Printing

Note: You cannot erase individual

1. Press and hold the outer two

function buttons simultaneously for

approximately 20 seconds until the

indicator lights above the buttons

flash rapidly.

2. When the indicator lights flash,

release the buttons. The codes for

all buttons are erased.