Memory - Roland MKS-20 Owner's Manual

d.
Memory
Cartridge
Using
the
Memory
Cartridge {M-16C), the edited
data of
all
the
banks
(1
to
8)
on
the
MKS-20
can be
saved.
The
saved
data can be loaded back
to the
MKS-20
at
any
time.
1)
Saving
®
Make
sure the Protect Switch on
the
Memory
Cartridge
is
set to the
ON
position.
(2)
Securely connect the
Memory
Cartridge to
the
Memory
Cartridge Holder
Q
on
the
front panel
with the
Protect Switch
side facing upward.
.,ss^
Usually, the
Protect
Switch
should be
set to the
ON
position.
@
Set the
Protect Switch on the Memory
Car-
tridge to the
OFF
position.
Now,
the
Memory
Cartridge
is
ready
to accept the
data from
the MKS-20's memory.
®
While
holding the Save
Button
®
down,
push
the Write Button
®.
When
the saving
Is
completed, the
Display
responds
with:
(5)
Return the
Memory
Protect Switch on
the
Memory
Cartridge to the
ON
position.
If
the
Memory
Protect
Switch has not
been
set to
the
OFF
position, the Display
will
react as
shown
below and
the saving cannot be done.
Set the
Protect Switch
on the
Memory
Cartridge
to the
OFF
position.
If
this
happens,
set
the
Protect
Switch on
the
Memory
Cartridge
to
the
OFF
position,
then repeat
the saving procedure.
15