Sharp disney DM004SH Owner's Manual page 15

Safety Precautions
FCC Notice
. This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
. Changes or modifications not expressly
approved by the manufacturer responsible
for compliance could void the user's
authority to operate the equipment.
FCC Information to User
This equipment has been tested and found to
comply with the limits of a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation; if this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the
equipment and receiver.
xiv
3. Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced
radio/TV technician for help.
FCC RF Exposure Information
Your handset is a radio transmitter and receiver.
It is designed and manufactured not to
exceed the emission limits for exposure to
radio frequency (RF) energy set by the
Federal Communications Commission of the
U.S. Government.
The guidelines are based on standards that
were developed by independent scientific
organizations through periodic and thorough
evaluation of scientific studies. The standards
include a substantial safety margin designed
to assure the safety of all persons, regardless
of age and health.
The exposure standard for wireless handsets
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg.
Highest SAR value:
Model FCC ID At the Ear
DM004SH APYHRO00091 0.590 W/kg
This device was tested for typical body-worn
operations with the back of the handset kept
1.5 cm from the body. To maintain
compliance with FCC RF exposure
requirements, use accessories that maintain a
1.5 cm separation distance between the
user's body and the back of the handset. The
use of beltclips, holsters and similar
accessories should not contain metallic
components in its assembly.
The use of accessories that do not satisfy
these requirements may not comply with FCC
RF exposure requirements, and should be
avoided.
The FCC has granted an Equipment Authorization
for this model handset with all reported SAR levels
evaluated as in compliance with the FCC RF
emission guidelines. SAR information on this model
handset is on file with the FCC and can be found at
https://fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
under the Display Grant section after searching on
the corresponding FCC ID (see table on the left).
Additional information on Specific Absorption
Rates (SAR) can be found on the Cellular
Telecommunications & Internet Association
(CTIA) Website at http://www.phonefacts.net.
On the Body
0.450 W/kg