Advertisement
MAXP4260N 4 CHANNEL AMPLIFIER APPLICATIONS
Front/Rear high pass, using a Z channel amplifier
for mono sub bass
The combination of a 2 and a 4 channel amplifier, utilizing their
built in crossovers. makes it a snap to put together a full system
with
front
and rear highs, with mono sub bass.
Interconnect cable checklist:
- Using good quality RCA cables. feed the front and rear outputs
of a head unit to the inputs of the 4 channel amplifier as shown.
- Also connect the LINE OUT of the 4 channel amplifier to the
LINE INPUT of the 2 channel amplifier as shown.
Mono bass woofer wiring'
Connect the mono speaker positive terminal to the lEFT +.
and its negative terminal to RIGHT -.
Switch setting checklist,
4 channel highs amplmer,
- 1f2CH X-OVER: HP
- 3/4CH X-OVER: HP
2 channel bass amplifier:
- X-OVER switch: LP
Crossover frequency control checklist,
- 4 channel highs amplifier:
Channels 1/2
- HIGH PASS: 100Hz
LOW PASS: NfA
Channels 3/4
- HIGH PASS:
100Hz
LOW PASS,
NjA
2 channel bass amplifier:
- HIGH PASS (Subsonic filter,: 10Hz to 40Hz
Please note that these frequency points are suggestions on(y.
Refer to the loudspeaker manufacturer specifications and
the section 'Setting up systems after installation for best
performance"
Level control checklist:
- Refter to the section "Setting up systems after installation
for best performance-
Mlnlmun
final loudspeaker
Impedances,
- Z ohm per channel in stereo mode.
- 4 ohm mono bridged.
FRONT
INPUTS
REAR
INPUTS
TOBI\TTERY+I2V
VIA FUSE
FUll. RANGE
SP&\KERS
Hide quick links:
Advertisement
