Kenmore 110.21302013 Use And Care Manual page 14

TROUBLESHOOTING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
First try the solutions suggested here for assistance and to possibly avoid a service call.
Jf you experience PesslbJe Causes SeJutlon
\_/asher won't run or fill,
washer stops working
or wash Right remains
on (indicating that the
washer was unabRe to fiH
appropdateRy) (cont.)
Washer not draining/
spinning, Roads are
still wet, or spin light
remains on (indicating
that the washer was
unabRe to pump out
water within 10 minutes)
Check proper eRectricaR suppRy.
Normal washer operation.
Washer may be tightly packed.
Not using HE detergent or using too
much HE detergent.
Empty pockets and use garment bags
for small items.
Used a cycle with a low spin speed.
The washer may be tightly packed
or unbalanced.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: if problems continue, contact an electrician.
Ud must be dosed for washer to run.
Washer will pause during certain phases of cycle.
Do not interrupt cycle.
Washer may be stopped to reduce suds.
The washer senses the dry load with short spins that may take
2 to 3 minutes before water is added. You may hear the hum of
the spins. This is normal.
Remove several items, rearrange load evenly in basket_ and add
detergent. Close lid and press START/PAUSE/Unlock Lid.
Do not add more than 1 or 2 additional garments after cycle
has started.
Do not add more water to the washer.
Only use HE detergent° Suds from regular detergents can
slow or stop the washers Always measure detergent and follow
detergent directions based on your load requirements.
To remove suds, cancel cycle. Select Rinse/Spin. Press START//
PAUSE/Unlock Lid. Do not add more detergent.
Small items may have been caught in pump or between basket
and tub, which can slow draining.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/speed spin
for your garment. To remove extra water in the load, select Drain/
Spin. Load may need to be rearranged to allow even
distribution of the load in the basket.
Tightly packed or unbalanced loads may not allow the washer
to spin correctly, leaving the load wetter than normal Evenly
arrange the wet load for balanced spinning. Select the Drain &
Spin cycle to remove excess water. See "Using Your Washer" for
loading recommendations. .j
14