Speaker Outputs - Peavey PVTMi 8B Operating Manual

Rear Panel
6
5 1 2 4 3
(1) EFFECTS FOOTSWITCH
This switch provides for the connection of the optional remote footswitch. Footswitch is used to
enable/disable reverb effects.
CAUTION: Connection of a voltage source into this jack will damage the mixer.

(2) SPEAKER OUTPUTS

These are two-conductor 1/4" speaker outputs. Each one is rated at 8 ohms minimum impedance. Total
minimum load for the amplifier is 4 ohms. You may connect either one 4-ohm, one 8-ohm or two 8-ohm
speakers. Do not operate below rated minimum impedance. For maximum power transfer, be sure to use
speaker cables and not instrument cables to connect to the speakers. We recommend the use of 18-gauge
or larger speaker wire.
(3) LINE SEND
This is a 1/4" two-conductor line output. It is intended to connect the mixer to the input of an external
effects device or additional power amp, or to send a submix to a larger P.A. system. This line-level
signal disconnects the main outputs.
(4) LINE RETURN
This is a 1/4" two-conductor line input. It is intended primarily to connect the mixer to the output of
an external effects device.
(5) POWER LINKING CONNECTOR
This is a standard IEC cable connector for use with standard voltages from AC wall outlets. Its safety
ground pin is connected to the chassis and should never be removed (or defeated in the line cord) for
any reason. The IEC connector contains an internal fuse holder. The fuse rating is 5 amperes.
(6) POWER SELECT SWITCH
This switch must be set properly for the local AC line voltage. Select between 115 (110-120 VAC) or 230
(220-240 VAC) using this switch.
8