Power Switch; Voltage Selector Switch; Speaker Outputs - Peavey PV 5300 Operating Manual

Back Panel
17
19
18
NOTE: Before changing
voltage or fuse value, make
sure unit is disconnected
from AC power.
21

(17) POWER SWITCH

This is the main power switch.
(18) AC POWER INLET:
This is the receptacle for an IEC line cord, which provides AC
power to the unit. Connect the line cord to this connector to
provide power to the unit. Damage to the equipment may result if
improper line voltage is used. (See line voltage marking on unit)
Never break off the ground pin on any equipment. It is provided
for your safety. If the outlet used does not have a ground pin, a
suitable grounding adapter should be used and the third wire
should be grounded properly.
To prevent the risk of shock or fire hazard, always make sure
that the amplifier and all associated equipment is properly
grounded.
NOTE: FOR U.k. ONLY
As the colors of the wires in the mains lead of this apparatus
may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows:
(1) The wire which is colored green and yellow must be connected
to the terminal which is marked by the letter E, or by the Earth
symbol, or colored green or green and yellow. (2) The wire which
is colored blue must be connected to the terminal which is
marked with the letter N, or the color black. (3) The wire which
is colored brown must be connected to the terminal which is
marked with the letter L, or the color red.
(19) FUSE
This is the main safety fuse for the AC line voltage. Only replace
with a fuse of the exact type and rating. If the fuse continues to
fail, do not replace the fuse again. Take the unit to an authorized
Peavey service center.
NOTE: If the main AC voltage is changed, the fuse must also be
changed to one of the appropriate rating for the voltage you are
20
switching to.

(20) VOLTAGE SELECTOR SWITCH

This switch allows the user to select between 115VAC / 60Hz or
230VAC / 50Hz. To change the voltage selector, you must first
unscrew and remove the plastic cover that protects the switch.
After changing the voltage, please replace the plastic cover to
ensure the voltage level is not inadvertently altered.
NOTE: The fuse MUST be changed to the appropriate value to
match the voltage you have selected. Please see the note on the
back of the mixer for the correct value.

(21) SPEAkER OUTPUTS

These are two-conductor 1/4" speaker outputs. Each one is rated
at 4 ohms minimum impedance. You may connect either one
4-ohm, one 8-ohm or two 8-ohm speakers to each output. Do not
operate below rated minimum impedance. For maximum power
transfer, be sure to use speaker cables and not instrument cables
to connect to the speakers. We recommend the use of 18-gauge
or larger speaker wire.