Clean Tape Entrance - Brady BBP 30 User Manual

Clean Tape Entrance

This procedure cleans the tape entrance, exit area and exit chute. The tape entrance can
become sticky because of adhesive buildup
Materials Required
• Cleaning Kit (Cat # B31-CCT), includes foam swabs, adhesive scraping tool, plastic bottle
(not available in all regions)
• Kimwipes
• Isopropyl Alcohol
• Compressed Air Bottle, purchased locally (e.g., HOSA AIR-464 Gear Duster)
To clean the tape entrance:
Lightly moisten a lint-free cloth with isopropyl alcohol.
1.
At the top of the tape entrance, rub along entire length of the tape entrance to remove the
2.
adhesive residue [2]. If necessary, use the adhesive scraping tool or other flat-edged tool,
covered with the Kimwipe, to push against the tape entrance to clean all of the residue
from the entrance.
Rev A
Note:
Clean the exit area
swab may be damaged when cleaning the exit area.
®
or other non-abrasive cloth
Always wear safety glasses when using compressed air.
Do not use isopropyl alcohol on the print head! Isopropyl alcohol may
permanently damage the print head.
after cleaning the sensors (see
CAUTION CAUTION
CAUTION CAUTION
35
Printer Maintenance
page 34). The cleaning
®
BBP 30 User's Manual