AEG L 82470 BI User Manual page 22

22 www.aeg.com
13.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
water properly.
•
the water.
•
not closed correctly. Please check the
door!
13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance does not
drain the water.
- The appliance does not fill with
- The appliance does not drain
- The appliance door is open or
Possible solution
• Make sure that the mains plug is connected to the mains
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• Deactivate the Child Lock function if it is on (if available).
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
• Make sure that the water tap is not clogged.
• Make sure that the filter of the inlet hose and the filter of
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the connection of the water inlet hose is
• Make sure that the drain hose is in the correct position. The
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the drain filter is not clogged. Clean the fil-
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without
• Set the drain programme if you set an option which ends
•
Wait until the mains supply is stable.
•
electronic elements of the appliance.
Switch off and switch on again.
•
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
socket.
low. For this information, contact your local water authority.
the valve are not clogged. Refer to "Care and cleaning".
correct.
hose may be too low.
ter, if necessary. Refer to 'Care and cleaning'.
drain phase.
with water in the tub.
- The mains supply is unstable.
- No communication between
- The anti-flood device is on.
WARNING!
Deactivate the appliance
before you do the checks.