16. ACCESSORIES......................37 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
The appliance must be connected to the water mains • using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. • If the mains power supply cable is damaged, it must •...
ENGLISH access to the mains plug after the • Do not put flammable products or installation. items that are wet with flammable • Do not touch the mains cable or the products in, near or on the appliance. mains plug with wet hands. •...
Page 6
7. Remove the polystyrene protection from the bottom. 3. Remove the internal film. 8. Pull up the appliance in vertical position. 4. Open the door and remove the polystyrene piece from the door seal and all the items from the drum.
Page 7
ENGLISH 11. Pull out the plastic spacers. 12. Put the plastic caps, that you find in the user manual bag, in the holes. The appliance must be level and stable. A correct adjustment of the appliance level prevents the vibration, noise and the movement of the appliance when in operation.
Page 8
If this occur, close the water tap and contact the authorized service centre to replace the hose. 3.5 Water drainage The drain hose should stay at a height of not less than 60 cm and not more than Make sure that the inlet hose 100 cm.
ENGLISH 5. Without the plastic hose guide: Put Make sure that the drain the drain hose in the spigot and hose end is not immersed in tighten it with a clip. Refer to the the water. There may be a illustration.
Page 10
• The Flecken option pre-treats and water than necessary. stubborn stains optimizing the • The steam as a quick and easy way to effectiveness of the stain remover. refresh the clothes. The gentle steam •...
ENGLISH 5. CONTROL PANEL 5.1 Control panel description 11 10 Programme dial Steam Plus touch button (Plus Display Dampf) Spin reduction touch button (U./Min.) Eco touch button (Eco) Time saving touch button (Zeit • Rinse Hold option Sparen) • Extra Silent option Rinse touch button (Spülen) •...
Page 12
5.2 Display Maximum load indicator. The indicator flashes during the laundry load estimation (refer to ProSense load detection paragraph) . Maximum laundry indicator. It blinks if the laundry amount exceeds the declared load. Door locked indicator. Delay start indicator.
ENGLISH Time saving indicator. Spin speed indicator. Rinse hold indicator. Extra silent indicator. Temperature indicator. The indicator appears when a cold wash is set. 6. KNOB AND BUTTONS 6.1 Ein /Aus When the display shows the indicators , the appliance does not Pressing this button for a few seconds heat the water.
Page 14
The display shows the indicator in order to improve its effectiveness. The door stays locked. The drum turns regularly to reduce creasing. This option is not You must drain the water to unlock available with a the door.
ENGLISH After touching theStart/Pause button, • In case of smaller load, touch this button twice to set an extra quick the display shows the indicator programme. the selected delay time and the appliance begins the countdown. The display shows the indicator This option can also be used 6.8 Spülen to shorten the Dampf...
Page 16
Programme Programme description White cotton and coloured cotton. Normal soil and light soil. Standard programmes for the Energy Label consumption Baumwolle values. According to regulation 1061/2010, the programme Baumwolle at 60 °C and the programme Baumwolle at 40 °C with the option are respectively the «Standard 60°C cot-...
Page 17
ENGLISH Programme Programme description White cotton items. This programme removes micro-organ- isms thanks to a washing phase with the temperature main- Anti-Allergie tained above 60°C for some minutes. This helps in removing germs, bacteria, micro-organism and particles. An additional rinsing phase ensures a proper removal of detergent residues and pollens/allergenic items.
Page 18
Programme temperature, maximum spin speed and maximum load Programme Default tempera- Maximum spin speed Maximum ture Spin speed range load Temperature range Washing programmes 40 °C 1400 rpm 8 kg 95 °C - Cold 1400 rpm - 400 rpm Baumwolle 40 °C...
7.2 Woolmark Apparel Care - Company for the washing of wool garments labelled as «hand wash» Green provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine. Follow the garment care label for drying and other laundry instructions.
ENGLISH comes on/goes off above the indicator. 9. BEFORE FIRST USE 1. Make sure that all transit bolts have 4. Pour a small quantity of detergent been removed from the appliance. into the compartment marked by 2. Make sure that the electrical power is 5.
Page 22
Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Maximum level for quantity of liquid additives. Flap for powder or liquid detergent. Always follow the instructions that you find on the packaging of the 4.
Page 23
ENGLISH The drain pump can operate shortly before the appliance fills water. 10.7 Starting a programme with the delay start 1. Touch the Zeitvorwahl button repeatedly until the display shows the desired delay time. The indicator comes on. 2. Touch the Start/Pause button. The appliance starts the countdown of Make sure that the flap does not cause a the delay start.
Page 24
After touching the Start/Pause button, E.g. the washing or pre wash phase is the maximum declared load indicator running: goes off, the indicator flashes, the ProSense starts the laundry load When the phase ends the relevant detection: indicator stops flashing and is steady on.
Page 25
ENGLISH After five minutes from the end of the If the ProSense phase is programme, the energy saving function already carried out and the automatically deactivates the appliance. water filling is already started, the new programme When you activate the starts without repeating appliance again, the display the ProSense phase.
• After 5 minutes from the end of the In any case, the appliance washing programme empties the water out Press the Ein /Aus button to activate automatically after the appliance again. approximately 18 hours. The display shows the end of the last set programme.
ENGLISH types of fabric, or special ones for • If you pre-treat the stains, you can use woollens only. a stain remover when you set a • Do not mix different types of programme with a low temperature. detergents. • To use the correct quantity of •...
Page 28
12.4 Door seal Regularly examine the seal and remove all objects from the inner part. 2. Remove the top part of the additive compartment to aid cleaning and 12.5 Cleaning the drum flush it out under running warm Regularly examine the drum to prevent water, to remove any traces of rust particles.
Page 29
ENGLISH 2. Place a suitable bowl below the drain 12.7 Cleaning the drain pump pump access to collect the water that flows out. WARNING! 3. Squeeze the two levers and pull the Disconnect the mains plug drainage duct forward to open it. from the mains socket.
Page 30
7. Close the drainage duct and turn the 11. Put the filter back into the special filter anti-clockwise to remove it. guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 8. If it is necessary, remove fluff and objects from the filter recess.
Page 31
ENGLISH 12.8 Cleaning the inlet hose and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1. Remove the inlet hose from the tap and clean the filter.
13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre.
Page 33
ENGLISH Problem Possible solution The appliance does not Make sure that the water tap is open. fill with water properly. Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged.
Page 34
Problem Possible solution Make sure that the washing programme is finished. Set the drain or the spin programme if there is water in the drum. Make sure that the appliance receives electrical power. This problem may be caused by a failure of the appliance.
ENGLISH Before opening the door: To open the door, proceed as follows: 1. Press the Ein /Aus button to switch CAUTION! the appliance off. Risk of burns! Make sure 2. Disconnect the mains plug from the that the water mains socket. temperature is not too 3.
Programmes Load Energy Water Approxi- Remain- (kg) consump- consump- mate pro- ing mois- tion (kWh) tion (litre) gramme ture (%) duration (minutes) Standard cotton programmes 0.49 Standard 60°C cotton 0.38 Standard 60°C cotton 0.34 Standard 40°C cotton 1) At the end of spin phase.
The tumble dryer can be stacked on the top of the washing machine only by www.aeg.com/shop or from using the correct stacking kit authorised dealer manufactured and approved by AEG. Only appropriate Verify the compatible accessories approved by stacking kit by checking the AEG ensure the safety depth of your appliances.
Page 38
Do not dispose appliances your local recycling facility or contact your municipal office. marked with the symbol with the household waste. Return the product to...