Basic Operation - Secura Key RADIO KEY 600 Quick Start User Manual

To Exit Programming Mode Immediately: To Exit Programming Mode Immediately: To Exit Programming Mode Immediately:
To Exit Programming Mode Immediately: To Exit Programming Mode Immediately:
Press MODE, press 1, then press ENTER. This returns the unit to normal mode
immediately, bypassing the 15 second timeout.
+ 1 +
(MODE)
PROGRAMMING HINTS PROGRAMMING HINTS
PROGRAMMING HINTS PROGRAMMING HINTS PROGRAMMING HINTS
Password: Password: Password:
Password: Password:
If the password is lost or forgotten it can be restored to the factory
default. Remove the RK600 unit from the mounting plate, disconnect power
(unplug the connector from J1 or disconnect the DC power supply) Press and
HOLD the reset switch (SW1, on the reader circuit board) restore power, then
release the switch. Note that this will also reset the latch timer and reader mode
to the factory default.
Latch Timer: Latch Timer:
Latch Timer:
Latch Timer: Latch Timer:
time can be changed to any value from 0.25-30 seconds. If the latch timer is set
to 0 seconds, this pulses the latch relay for 0.25 second, sufficient for most electric
turnstiles. The beeper and green LED are always fixed at one second.
Operating Mode: Operating Mode:
Operating Mode: Operating Mode: Operating Mode:
operation select Mode 1; to temporarily lock all transponders out select Mode 2;
to hold the door open continuously select Mode 3.

BASIC OPERATION

BASIC OPERATION BASIC OPERATION
BASIC OPERATION BASIC OPERATION
USING RADIO KEY
To use Radio Key
Unit or optional Auxiliary Reader. If the Transponder ID Number is stored in
memory, the latch relay is activated, unlocking the controlled door or gate and
shunting any external alarms. A green light and a beep indicates that access is
granted. If the Transponder ID Number is not stored in memory, the door or gate
remains locked and a red light and three rapid beeps indicate that access is
denied. Otherwise the LED is normally off.
USING KEYPAD ENTRY
For PIN entry, enter your User Number, 4-digit PIN, then press
can be omitted for the user number, but can't be omitted for the PIN Code.
(ENTER)
The latch timer controls the latch/alarm shunt relay. The latch
Three operating modes are possible. For normal
® TRANSPONDERS
®
600, simply hold your Radio Key
www.SecuraKeyStore.com
(800) 878-7829
sales@securakeystore.com
®
Transponder near the RK600
* . Leading zeroes
5428