Setting Up Independent Vlan Workgroups (Tagged & Untagged) - HP WL520 User Manual

1. In the Web Interface, click the
unique unique unique unique
2. Enter a Network Name Network Name
Network Name Network Name
3. Select the tab and select the
Network Network Network Network
unique unique unique unique
4. Set a VLAN User ID for each wireless NIC (enter a value between 1 and 4094).
5. Place a checkmark in the Enable VLAN Protocol box.
6. Configure the wireless client with one of the two
setting up independent vlan workgroups (tagged & untagged) setting up independent vlan workgroups (tagged & untagged) setting up independent vlan workgroups (tagged & untagged) setting up independent vlan workgroups (tagged & untagged)
The VLAN-capable WL520 supports configuration of both "tagged" and "untagged" user VLANs.
A "tagged" user VLAN is created when a VLAN ID between 1 and 4094 (per the 802.1Q standard) is configured for one of
the wireless NICs and VLAN is enabled. The WL520 applies a VLAN header to tag traffic from wireless clients (members of a
"tagged" VLAN) and transmits the traffic as appropriate, on either the wired or wireless backbone.
An "untagged" User VLAN is created when a VLAN ID of 0 is configured for one of the wireless NICs and VLAN is enabled.
Traffic received from wireless clients (members of an "untagged" VLAN) is transmitted as appropriate, on either the wired or
wireless backbone. "Untagged" User VLANs enable VLANs to coexist on networks with non-VLAN capable devices such as
legacy servers.
To configure this scenario, set up only one workgroup by configuring one tagged interface and one untagged interface:
VLAN ID for Wireless NIC in Slot A = 0 or a number between 1 and 4094
VLAN ID for Wireless NIC in Slot B = 0 or a number between 1 and 4094
NOTE:
Either the wireless NIC in Slot A or the wireless NIC in Slot B must be set to 0.
Figure 4-5 Figure 4-5 VLAN Configuration Screen (Wireless A Tagged Only) VLAN Configuration Screen (Wireless A Tagged Only)
Figure 4-5 Figure 4-5 VLAN Configuration Screen (Wireless A Tagged Only) VLAN Configuration Screen (Wireless A Tagged Only)
1. In the Web Interface, click the
unique unique
2. Enter a unique unique
Network Name Network Name Network Name Network Name
3. Select the Network Network tab and select the
Network Network
4. Set the for one NIC to 0.
VLAN UserID VLAN UserID VLAN UserID VLAN UserID
5. Set the VLAN User ID VLAN User ID for the other NIC to a value between 1 and 4094.
VLAN User ID VLAN User ID
6. Place a checkmark in the Enable VLAN Protocol box.
7. Configure the wireless client with one of the two
button and select the
Configure Configure Configure Configure
(SSID) for each wireless network interface card (NIC).
sub-tab.
VLAN VLAN VLAN VLAN
Network Names Network Names Network Names Network Names
Configure Configure button and select the
Configure Configure
(SSID) for each NIC.
VLAN VLAN sub-tab.
VLAN VLAN
Network Names Network Names Network Names Network Names
tab.
Interfaces Interfaces Interfaces Interfaces
based on VLAN membership.
Interfaces Interfaces tab
Interfaces Interfaces
based on VLAN membership.
VLAN Support
4-6