Egress Vlan; Wireless Security Filters - HP MSM3xx Management And Configuration Manual

Working with VSCs
VSC configuration options
To ensure a high quality of service for voice applications, disable all rates below 5.5. Also,
ensure that the radio is configured as follows:
 Operating mode is set to Access point only.
 Channel is set to a fixed channel, or Automatic with interval set to Disabled.
 Automatic power control is disabled under Transmit power control.
On the Wireless > Neighborhood page, do not enable the Repeat scan every nnn

seconds option.
Notes on the 802.11n
802.11n supports legacy rates (1 to 54), and high-throughput (HT) rates MCS 0 to MSC 23.
 MCS 0 to MCS 15 are supported by the MSM410, MSM422 (radio 1), E-MSM430,
E-MSM460, and E-MSM466.
 MCS 16 to MCS 23 are supported by the E-MSM460 and E-MSM466.
You must always enable at least one legacy rate for 802.11n.
Notes on the E-MSM430, E-MSM460, and E-MSM466
On these products, the wireless rates shown apply to all wireless modes supported on both
radios, which are 802.11n/a/b/g. If you remove a rate, it is removed for all wireless modes.

Egress VLAN

Sets the VLAN to which this profile forwards traffic. If you do not select a VLAN, traffic is
sent untagged. VLAN s can also be assigned using other methods, some of which may
override the Egress VLAN. See

Wireless security filters

APs feature an intelligent bridge that can apply security filters to safeguard the flow of
wireless traffic. These filters limit both incoming and outgoing traffic as defined below and
force the AP to exchange traffic with a specific upstream device.
 If Use HP MSM Controller is enabled under General, the AP will only forward user
traffic that is addressed to the access controller (MSM7xx Controller) defined on the
Security > Access controller page. All other traffic is blocked. Make sure that the
access controller is set as the default gateway for all wireless users. If not, user traffic
will be blocked by the AP. The default wireless security filters are in effect.
4-14
VLAN support on page 5-5 for details.