Secura Key Radio Key 600 Operating & Installation Manual page 8

Radio Key
®
PROGRAMMING STEPS
To Enter Program Mode:
Enter your 5-digit password, then press ENTER.
programmed with the password 12345.) The LED will flash amber to show
that the unit is in Program Mode. The unit will "time out" and return to Active
(Normal) Mode in 15 seconds if no key is pressed.
1 + 2
Add a Transponder (Key Tag) to the System:
Enter Password. Press ENTER. Press ADD. Enter a User Number (1 - 600) and
press ENTER. Hold the Transponder near the RK600 Unit. A green light and
beep means that the Transponder was accepted. A red light and three beeps
means a Transponder has already been stored for the selected User Number.
Delete the previously stored Transponder or select a new User Number.
+ 1
(User Number 12)
(ADD)
Add a Transponder by Entering the Transponder ID:
Instead of presenting the transponder, you can also use the Keypad to enter the
Transponder ID number: Enter Password. Press ENTER. Press ADD, enter the User
*
Number, press
+ 1
(ADD)
(User Number 12)
Record the User Number and Transponder ID Number in the User Log Form.
Add a Series of Transponders to the System:
Enter Password. Press ENTER. Press ADD. Enter the Starting User
Number in the range. Press
press ENTER. Present the Transponders to the reader in the desired order
(making a careful record of which transponders are assigned to which User
Numbers). If one or more Transponders are already entered into the User
Number range you have selected, a red light and three beeps will occur, in
which case, you must delete the entire range before proceeding.
+ 1 +
(Starting User No. 1)
(ADD)
600
+ 3 + 4
(Password)
+ 2 +
, enter the ID number printed on the Transponder, then press ENTER.
+ 2 +
*
*
+ 1
(Ending User Number 10)
Secura Key  4
Operating & Installation
+ 5 +
(Hold Key Tag near unit)
(ENTER)
*
+ 9 + 9 +
(ID Number 995)
, enter the Ending User Number, press
+ 0 +
(All new units are pre-
(ENTER)
5
*
+
(ENTER)
+
(ENTER)
*
, then