Programming Hints; Basic Operation - Secura Key Radio Key 600 Operating & Installation Manual

Radio Key 600 Operating & Installation
®

PROGRAMMING HINTS

Password
If the password is lost or forgotten it can be restored to the factory default.
Remove the RK600 unit from the mounting plate, disconnect power (unplug
the connector from J1 or disconnect the DC power supply) press and HOLD
the reset switch (SW1, on the reader circuit board), restore power, then
release the switch. Note that this will also reset the latch timer and operating
mode to the factory default.
Adding the Same Transponder More Than Once
If you add the same Transponder to the system more than once, the
Transponder ID will be deleted from the previous User Number position and
added to the newest User Number position. This does not apply to duplicate
PIN codes; the same PIN can be assigned to multiple User Numbers.
Setting the Latch Timer
The latch timer controls the latch relay, which has two sets of contacts; one
for unlocking the door or gate, and one for bypassing an external alarm
system. The factory preset latch time is 1 second but it can be changed to
any value from 0.25-30 seconds. If the latch timer is set to 0 seconds, this
pulses the latch relay for 0.25 second, sufficient for most electric turnstiles.
The beeper and LED are always fixed at one second.
Setting the Operating Mode
Three operating modes are possible. For normal operation select Mode 1;
to temporarily lock out all transponders and PIN Codes select Mode 2; to
hold the door open continuously select Mode 3.

BASIC OPERATION

To use a Key Tag with Radio Key 600, simply hold your Radio Key
® ®
Transponder near the RK600 Unit or optional Auxiliary Reader. The RK600
Unit or Auxiliary Reader generates an RF field, which causes the Key Tag
to transmit a unique Transponder ID Number back to the Auxiliary Reader
or RK600 Unit.
If the Transponder ID Number is stored in memory, the latch relay is activated,
unlocking the controlled door or gate and shunting any external alarms. A
green light and a beep indicates that access is granted.
Secura Key  7