Bosch IXO Original Instructions Manual page 32

32 | English
Note: The battery supplied is partially charged. To ensure full capacity of the
battery, completely charge the battery in the battery charger before using
your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging procedure does not damage the battery.
The Lithium-Ion battery is protected against deep discharging. When the bat-
tery is discharged, the machine is automatically switched off by a protective
circuit: The inserted tool no longer moves and a slight whistling noise can be
heard.
 Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
When the battery charge-control indicator 5 lights up red while the On/Off
switch 8 is depressed half way, then the battery has less than 30% of its ca-
pacity and should be charged.
The charging procedure starts as soon as the main plug of the battery charger
is inserted into the socket and the cordless screwdriver is afterwards placed
on the battery charger 12.
The battery charge-control indicator 5 indicates the charging progress. The
indicator lights up green during the charging process. When the battery
charge-control indicator 5 is no longer lit, the battery is fully charged.
During the charging procedure, the handle of the machine warms up. This is
normal.
Disconnect the battery charger from the mains supply when not using it for
longer periods.
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
 Protect the battery charger against moisture!
Observe the notes for disposal.
Changing the Tool (see figure B)
 Do not use double-sided screwdriver bits that are longer than 25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
1 609 92A 0P3 | (6.8.14) Bosch Power Tools