Loewe Connect 55 User Manual page 120

Connect 32 DR+ - Connect 55
User manual
External devices
Connecting a DVD recorder to the TV set
A DVD recorder has been selected in the System settings
Connections AV connecting settings
tion AV.
Switch off all devices before connecting them.
Connect the Scart output of the DVD player to the TV set's AV socket
using the Scart adaptor (1 . Use a fully equipped Scart cable (available
from your dealer) for this.
If you want to receive and record analogue stations with the receiver
(tuner) built into the recorder, the recorder must be looped into the
aerial cable.
Connect the DVD recorder as shown in the connection example below.
R
TV
DVD recorder
AV
ANT IN
ANT OUT
Playback from AV device
Call AV list.
AV list 7 7 AV AV
8 8 VIDEO VIDEO
Select AV,
OK switch over.
Start playback on the connected device.
(1 Adaptor is available as an accessory (see chapter Accessories).
120
Device at connec-
TV set
ANT TV AV
Connection example of a DVD recorder
Note: If you press
at least two seconds to
switch to the selected
channel, the screen
switches off and you will
only hear the sound.
With the button
(green), you can switch
the screen back on and
off.
Connecting PC / Set-top box
You can connect a PC and thus use the TV screen as a monitor.
When connecting a PC or auxiliary device to the AV socket of the
TV set, adjust the output signal on your PC first so that it matches
one of the signals in the table in chapter Technical data, section
Signals via AV (PC IN) / HDMI.
Switch off all devices before connecting them.
Connect the device to the TV set's AV socket with a VGA cable and
the VGA adaptor (1 .
Connect the analogue audio signal of the PC to the VGA adaptor via
the jack plug socket.
PC
AUDIO VGA
Playback from the device
Call AV list.
AV list
for
OK
Select PC IN,
OK switch over.
Adjusting the geometry of the PC picture
You can set the position (vertical, horizontal) and the phase position of
your PC. The settings you find under System settings
more ... PC IN - Display.
Connecting devices with component connection (YPbPr / YUV)
External units with component connection YPbPr (often informally
referred to as YUV; see also Glossary) can be connected to the AV
socket of the TV set using two adaptors. In addition to the VGA adaptor,
a component VGA adaptor is required (available from your dealer).
The other units are connected as described in the left column.
TV set
Connection example of a PC
5 5 PC IN PC IN
6 6 AVS AVS
7 7 AV AV
8 8 VIDEO VIDEO
AV
Note: If you press for
OK
at least two seconds to
switch to the selected
channel, the screen
switches off and you will
only hear the sound.
With the button
(green), you can switch
the screen back on and
off.
Picture