Sensor Status - JRC JHS-183 Instruction Manual

5.3.3.4. Sensor Status

Select 4.SENSOR STATUS
"SENSOR STATUS" screen is displayed.
Also the next page is displayed with obtaining information of sensor device (ID) and command status.
When the display is switched to "MAINTENANCE" menu screen, press CLR key.
S E N S O R
P O S I T I O N :
E X T E R N A L
U T C C L O C K : I N
S O G / C O G : E X T E R N A L
H E A D I N G : V A L I D
R O T : I N
▼
1 / 2
S E N S O R
I D
▲
P O S N : G P
S O G : G P
C O G : G P
H D G : H E
R O T : T I
2 / 2
Sensor status displays are as follows:
Sensor Type Display
EXTERNAL DGNSS
EXTERNAL GNSS
INT DGNSS(BEACON)
POSITION
INT DGNSS(MSG.17)
INTERNAL GNSS
NO SENSOR
LOST
UTC CLOCK
IN USE
EXTERNAL
SOG/COG INTERNAL
NO SENSOR
VALID
HEADING
INVALID
IN USE
ROT OTHER SOURCE
NO SENSOR
The detail of sensor ID is shown at next page.
About the detail of command, refer to "8.3.4 Supported interface sentences".
5-44
at "MAINTENANCE" menu screen (refer to "5.3.3 MAINTENANCE"),
S T A T U S
G N S S
U S E
U S E
S T A T U S
C O M M A N D
R M C
R M C
R M C
H D T
R O T
Explanation
Data is obtained from the external GPS (high accuracy).
Data is obtained from the external GPS (low accuracy).
Correction data is obtained from the beacon receiver and the
internal GPS is used (high accuracy).
Correction data is obtained from the base station and the internal
GPS is used (high accuracy).
Data is obtained from the internal GPS (low accuracy).
No data is available.
The internal GPS is not synchronized with PPS.
The internal GPS is synchronized with PPS.
Data is obtained from the external equipment.
Data is obtained from the internal GPS.
No data is available.
Data is obtained from the external equipment.
No data is available.
Data is obtained from the rate-of-turn indicator.
Data is obtained from the equipment other than the rate-of-turn
indicator.
No data is available.