Ais Alarm - JRC JHS-183 Instruction Manual

5.3.3.3. AIS Alarm

Select 3.AIS ALARM
ALARM" confirmation screen is displayed.
"ALARM HISTORY" screen can be displayed up to 50 from last defective alarms during the operation.
When the display is switched to "MAINTENANCE" menu screen, press CLR key.
A I S A L A R M
2 0 1 2 / 0 5 / 1 7
0 2 5 , A , V
F S L O S T
1. Current Alarm status
A current occurring alarm list is displayed in "ALS ALARM" screen.
- When the AIS alarm doesn't occur, "NO DATA" is displayed.
- When alarms are occurring and "▼" mark is displayed on the bottom line, this means that there are
contents in the next page. When there is nothing in the next page, "▼" mark is not displayed on the
bottom line.
- In order to see the next page, press ▲ key or ▼ key.
The screen displays consecutive items, press ▲ key or ▼ key to see next items.
2. Alarm history
When SUB key is pressed at "ALS ALARM" screen, the screen is switched to "ALARM HISTORY"
screen.
Up to 50 occurred and restored alarms can be confirmed.
When the display is switched to "ALS ALARM" screen, press SUB key or CLR key.
- When "▼" mark is displayed on the bottom line, This means that there are contents in the next page,
Therefore press ▲ key or ▼ key to see next.
- Time of all occurred alarm and all their restorations is displayed with UTC.
If the time cannot to be acquired, " --/--/-- --:-- " is displayed there.
- A description of alarm display is shown below.
Alarm contents: 035, V, A, no valid ROT information
(1): The alarm number (refer to the next page)
(2): The alarm condition -> "V": Alarm is restored
(3): Not used
(4): Alarm's description text (refer to the following table)
5-42
at "MAINTENANCE" menu screen (refer to "5.3.3 MAINTENANCE"), "AIS
0 2 : 1 0
E X T E R N A L E P
AL
(1) (2) (3)
"A": Alarm is occurring
SUB key
A L A R M
1 . 2 0 1 2 / 0 5 / 1 7
2 . 2 0 1 2 / 0 5 / 1 6
▼
SUB / CLR key
(4)
H I S T O R Y
0 2 : 1 0
0 2 5 , A , V E X T E R N A L
E P F S L O S T
2 3 : 4 0
0 3 5 , V , A N O
R O T I N F O M A T I O N
V A L I D