Preparing The Setup Wizard; Power Cord; R6/Aa Batteries - Denon DN-500AV Getting Started

EnGlish DEutsch

Preparing the Setup Wizard

This section describes how to prepare the Setup Wizard before use.
n Do not plug the power plug of the main unit into the wall socket until these preparations are complete.
n Speaker connections are performed using the Setup Wizard.
What you need for this step
Speaker
(sold separately)
z
C SBL
z
FL FR
SL SR SBR
• Prepare enough for the
number of speakers you will
z If you wish to set 7.1-channel,
use.
prepare a surround back speakers.
Subwoofer (with built-in amplifier)
(sold separately)
TV
(sold separately)
Remote control unit /
R6/AA batteries (supplied)
Power cord (supplied)
or
European,U.K and
Asia/Pacific
2
Français Español
1
Place and layout speakers
Speaker cable
Before installing the speakers, connect the speaker cables to the speakers. For details on how to connect the speaker cables, see
(sold separately)
the speaker instruction manual.
n When 5.1-channel installed
Audio cable
(sold separately)
HDMI cable
(sold separately)
FL
Power Amplifier
FR
(sold separately)
C
SW
SL
SR
SBL
SBR Surround back speaker (R)
USA and Canada
FL FR
SW
C
z1
z2
SL
SR
Listening position
z1 22˚ – 30˚ z2 120˚
Front speaker (L) • Install the surround speakers in a position 2 to 3 ft (60 to 90 cm) higher than ear
Front speaker (R) level.
Center speaker
Subwoofer
Surround speaker (L)
Surround speaker (R)
Surround back speaker (L)
n When 7.1-channel (Surround back speaker) installed
FL
SW
C
z1
z2
z3
SL
Listening
position
SBL SBR
z1 22˚ – 30˚ z2 90˚ – 110˚
Surround
speaker
Surround back speaker
Front
(When 7.1-channel installed)
speaker
2 – 3 ft /
• Point slightly downwards
60 – 90 cm
GViewed from the sideH
FR
SR
z3 135˚ – 150˚