Custom Master Tv Setup Procedure - LG 32LX570H Commercial Mode Setup Manual

Custom Master TV Setup Procedure

1. Turn ON the TV.
The next step depends on whether the EZ-Manager Wizard appears
on the screen when you turn ON the TV:
• If the wizard is displayed, the TV is in the required factory default state.
Exit the wizard, and then continue with step 2.
• If the wizard is not displayed, restore the TV to a factory default
condition before continuing with this procedure. See Reference
section, "Restoring Factory Defaults on the TV(s)," as necessary,
for further information.
2. Set Installer Menu items.
This step provides specific instruction only on the Installer Menu items
that should be set on a Master TV. Refer to pages 22 to 31 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
"Accessing the Installer Menu" on page 22 for further information).
b) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 0.
• CATV: Set to 1 (default).
c) Set any other Installer Menu items that affect your TV programming
network to the required configuration. For example, enable/disable
Aux inputs, set a Start Channel, etc.
d) After you have adjusted all Installer Menu item settings as required,
and if you do not need to configure any IP Environment settings (see
note below), press OK once on the Installer Remote to save your
changes; then, press OK again to exit the menu.
Note: If you intend to configure settings in the IP Environment Menu,
which is accessible from the Installer Menu, you can proceed directly
to step 3. All Installer Menu settings will be saved automatically when
you access the IP Environment Menu.
3. Configure IP Environment settings.
Note: You cannot return directly to the Installer Menu from the IP
Environment Menu; thus, you may wish to set all Installer Menu items
as needed before you access the IP Environment Menu. Otherwise,
you will need to reaccess the Installer Menu to set additional items.
Navigate to Installer Menu item 119 DATA CHANNEL, and press
2-5-3 + MENU SETTINGS to launch the IP Environment Menu. Then,
complete network configuration as required. See "IP Environment
Setup" on pages 45 to 48 for further information.
206-4278
• HRC: Set to 2.
• IRC: Set to 3.
Custom Master TV Setup (Cont.)
xxLX570H PTC INSTALLER MENU
000 INSTALLER SEQ
UPN 000-000-000-000
PTC V1.00.008
003
Installer Menu item, as required.
CPU-CTV
000
ASIC D279
CPU V3.00.20.01
Typical Installer Menu
BAND/AFC 001
Adjust the value for this
(Continued on next page)
33