LG 32LX570H Commercial Mode Setup Manual page 17

(Continued from previous page)
IP Configuration
a) In the Media Type field, use the Left/Right arrow keys to
select IP.
Note: By default, the Pro:Centric Manual Configuration
screen initially shows RF configuration fields. When you
select "IP" as the Media Type, the Data Channel and
Signal Strength/Quality fields are replaced with IP Address
and Port fields.
b) In the Address and Port fields, either key in or use the
Left/Right arrow keys to select the appropriate values for
the Pro:Centric server IP address and port number.
The IP address must match the IPv4 multicast address
and the port number must match the port number that is
set in the Pro:Centric server.
4. Once all fields are completed as required, you have two
options (see also note below):
• To save the data entered and exit the wizard, use the arrow
keys to select Exit and then press OK. In the subsequent
pop-up confirmation window, select Save and Exit, and then
press OK once more. The Pro:Centric application and/or
E-Z Installation data will be downloaded to the TV at a later
time. This option is useful, in particular, if the Pro:Centric
server has not yet been configured.
• To initiate a real-time download of Pro:Centric application
and/or E-Z Installation data, use the arrow keys to select
Next, and then press OK.
The EZ-Manager Wizard will proceed with the remaining
Pro:Centric application and/or E-Z Installation data down-
load steps, as shown on the Processing the Pro:Centric
Configuration screen.
Note: With RF configuration, Pro:Centric server data must be
present on the RF channel selected as the TV's Data Channel
in order for you to select "Next" (you will see a "Data channel
found" message below the Signal Quality indicator). With IP
configuration, Pro:Centric server data must be present via the
wired LAN cable connection in order for you to select "Next"
(you will see a "IP server found" message below the Port field).
When the Pro:Centric configuration is complete, an EZ-Manager
Configuration Complete screen is displayed, and after 10
seconds, the wizard exits, and the TV turns OFF.
Note: With the EZ-Manager Configuration Complete screen on
display, you also have the option to manually turn off or reboot
the TV. If desired, select Turn Off or Reboot, respectively, and
then press OK on the Installer Remote.
206-4278
EZ-Manager Wizard (Cont.)
EZ-Manager Wizard
2
3 4
1
Pro:Centric Manual Configuration
Pro:Centric Mode
<
Media Type
Addresss 255
Port
Back Exit
Pro:Centric Manual Configuration Screen with
IP Media Fields
EZ-Manager Wizard
2
3 4
1
Pro:Centric Manual Configuration
Are you sure you want to exit the wizard?
!
<
Pro:Centric Mode
If you select 'OK' now, your settings will be lost
and you will exit the setup wizard.
Channel Number
Signal Strength This window will close and you will be returned to
the previous page automatically in 2 seconds.
Signal Quality
Save and Exit OK
Back Exit
EZ-Manager Wizard
3
1 2 4
Processing the Pro:Centric Configuration...
Downloading the Pro:Centric application files takes a few minutes.
Please wait...
Retrieving files from data channel 75
Application files
Maintenance files
Warning - Do not remove AC power or the signal cables during these steps
EZ-Manager Wizard
4
1 2 3
EZ-Manager Configuration Complete
The TV will turn off in 3 second(s).
Installed Components
Pro:Centric Application
Maintenance Files
Reboot
GEM
>
IP
255 255 255
0
Next
>
GEM
1
0%
0%
Cancel
No signal
Next
1%
In progress...
Pending...
GEM application downloaded
LX570H_Config.tlx
Turn Off
17