LG 32LX570H Commercial Mode Setup Manual page 16

EZ-Manager Wizard (Cont.)
(Continued from previous page)
Note: If, after completing the search, the TV is unable to find the
Pro:Centric data channel (while the Searching for Pro:Centric
Server screen is on display), the wizard will stop and show a
Diagnostics screen that enables you to manually return to the
previous screen (to reinitiate the configuration) or exit the wizard.
When the Pro:Centric Configuration is complete, an EZ-Manager
Configuration Complete screen is displayed, and after 10
seconds, the wizard exits, and the TV turns OFF.
Note: With the EZ-Manager Configuration Complete screen on
display, you can also manually turn off or reboot the TV. If
desired, select Turn Off or Reboot, respectively, and then press
OK on the Installer Remote.
Manual Pro:Centric Configuration
1. With the Searching for Pro:Centric Server screen on display,
use the arrow keys on the Installer Remote to select/highlight
Manual Pro:Centric at the bottom right of the screen, and
then press OK.
In the Pro:Centric Manual Configuration screen (see examples
at right below and on following page), you will be able to
configure the appropriate Pro:Centric settings in the TV. Use
the Up/Down arrow keys on the Installer Remote to navigate
between fields.
2. In the Pro:Centric Mode field, use the Left/Right arrow keys to
select the appropriate Pro:Centric Application Mode—FLASH,
GEM, or Configuration Only.
Note: For remote management only, select Configuration
Only. The TV will search for TV E-Z Installation data down-
loads; however, Pro:Centric application data will not be
downloaded, i.e., Installer Menu item 098 PRO:CENTRIC
will be set to 0.
3. Refer to the appropriate subsection below, depending on the
Pro:Centric server configuration, to complete the remaining
fields.
RF Configuration
a) In the Media Type field, use the Left/Right arrow keys to
select RF.
b) In the Data Channel field, either key in or use the Left/
Right arrow keys to select the RF channel number that
will be used by the Pro:Centric server as its data channel.
The Data Channel value can be set from 1 to 135. *
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
16
EZ-Manager Wizard
4
1 2 3
EZ-Manager Configuration Complete
The TV will turn off in 3 second(s).
Installed Components
Pro:Centric Application
Maintenance Files
Reboot
Z
EZ-Manager Wizard
2 4
1 3
Searching for Pro:Centric Server...
It may take 1 min 32 second(s).
This step automatically searches for the Pro:Centric server.
If there is no Pro:Centric Server installed, you do not need to continue
with this procedure. Please select either 'Exit' or 'Manual Pro:Centric'.
Status : Tuning channel 49
TV is now searching all of the channels for the data channel...
Back
EZ-Manager Wizard
2 3 4
1
Pro:Centric Manual Configuration
Pro:Centric Mode
Media Type
Data Channel
Signal Strength
Signal Quality
Back
Pro:Centric Manual Configuration Screen with
RF Media Fields
GEM application downloaded
LX570H_Config.tlx
Turn Off
Exit Manual Pro:Centric
< >
GEM
RF
1
0%
0%
No signal
Exit Next
(Continued on next page)
206-4278