Print Head Open / Close - Paxar 656 / 636 User Manual

Print Head Open / Close

16 • Printer Operation
The only other adjustment for the back of the web is the back stacker up-right rail.
To move the location of the up-right loosen the knob under the stacker and slide the
unit in or out as needed. The up-right rail should be located approx. 1/16" (1.5mm)
to the back of the label or tag as it enters the stacker.
The print head module is to be opened and closed for threading the stock and ink.
The unit must also be opened to clean the head and for print head replacement.
Later in the manual, under separate heading, cleaning and replacement will be
covered.
The print head has an interlock switch that prevents the printer from running with
the head in the open position. If the head is open the display will read GUARD
OPEN. Both the top cover and head use the same command.
WARNING: DO NOT TOUCH THE PRINT HEAD WITHOUT WEARING THE
ANTI-STATIC GLOVES AND THE STATIC WRIST STRAP.
To open the print head for threading supplies, press the lower portion of the latch
(see figure ). The head mount plate will hinge from the back to swing open.
Figure Print Head Open / Closed
To close the head mount plate, move the head down while depressing the latch.
When the mount plate swings past the top of the latch release
Users Manual Model 656/636