Changing The Snap-On Presser Foot; Changing The Presser Foot "Ankle" - Husqvarna ZIGZAG 1030 Operating Manual

I
Changing the snap-on presser foot
.I.•
I
The presser feet
wchich
accompany the machine
7
h'ethe form of loose soles w.hich are held in place
i
on th presser foot "ankile" b5 a spring, If you wish
I
to change the presser foot, turn the hand wheel to-
wards you until the needle is in the highest posi ion.C
Renmove the presser foot by drawing it towards you
whlepressing s,lightly dwwrs
I
Slide the new presser foot over the front edge of
Ithe
ankle bracket as shown in the illustration. There
•
is a spring on the lower end of the ankle bracket.
Slide on thle presser foot so that the round trans-
iverse pin on the presser foot fits in to the space be-
tw,een the bracket and the spring. Then press lighth'
backwards and dow,nwards and the presser root will
q=..,,
snpinto the correct position.
I
Changing the presser foot "ankle"
-
'Certain presser feetl cannot be constructed as loose
soles and then the ankle bracket must also be
ichanged Make sure that the needle is in its highest
poiion, T'hen loosen the retaining screw w,ith your
lethand tuse the s,crc•d river if it is too tight) alnd
I remoe
I
le presser foot with •our right band.
[7