Casio EX-FR100CA User Manual page 16

IMPORTANT!
• The first time you connect the camera to your computer with the USB cable, an
error message may appear on your computer. If this happens, disconnect and then
reconnect the USB cable.
• A battery that has not been used for a long time, certain types of computers, and
connection conditions can cause charging to take longer than normal. These
conditions may also cause the operation lamp to flash red. If this happens, refer to
page 70.
• For faster charging, use of the supplied USB-AC adaptor is recommended.
• Charging is not performed while the connected computer is in the hibernate mode.
Other Charging Precautions
• With the two charging methods described above, you can charge the battery.
Never use any other type of charger device. Attempting to use a different charger
can result in unexpected accident.
• This model can be charged only via from USB 2.0 specification USB port.
• USB charging devices and power supply devices are subject to fixed standards.
Use of an inferior device or a device that is not up to standard can cause
malfunction and/or failure of your camera.
• Operation is not guaranteed in the case of a computer built or modified by you.
Even in the case of a commercially available computer, certain USB port
specifications may make it impossible to charge via the USB cable.
• A battery that is still warm immediately after normal use may not charge fully. Give
the battery time to cool before charging it.
• A battery discharges slightly while it is loaded in the camera. Because of this, it is
recommended that you charge the battery immediately before you need to use it.
• Charging the battery may cause interference with TV and radio reception. If this
happens, plug the USB-AC adaptor into an outlet that is further away from the TV
or radio.
• Actual charging time depends on current battery capacity and charging conditions.
• Do not use the USB-AC adaptor with any other device.
• Never use the power cord with another device.
• Use only the USB-AC adaptor and USB cable specified in this manual for charging.
Use of any other type of devices may result in improper charging.
• Leaving the camera with a dead battery for about eight days will cause its date and
time to be reset to their initial defaults. If this happens, use EXILIM Connect or the
controller that comes with a separately available CASIO camera (page 4) to
configure date and time settings. For details, refer to the user documentation that
comes with EXILIM Connect and the other camera.
16
Quick Start Basics