Table of Contents
Advertisement
IMPORTANT!
• A battery that has not been used for a long time and/or ambient temperature can
cause charging to take longer than normal. These conditions may also cause the
operation lamp to flash red. If this happens, refer to page 70.
• The USB-AC adaptor will become warm during charging. This is normal and does
not indicate malfunction.
• The shape of the power plug depends on each country or geographic area.
If the operation lamp is not lit or flashing during charging, check the orientation of the
USB cable connector.
• Make sure that you insert the cable connector into the USB port until you feel it
click securely into place. Failure to insert the connector fully can result in poor
communication or malfunction.
• Note that even while the connector is fully inserted, you
still will be able to see the metal part of the connector
as shown in the illustration.
. To charge using a USB connection to a computer
While the camera is turned off, connect in the sequence shown below (
Charging time
:
Approximately 2 hours 55 minutes
1
[USB] cover
Connect the cable so the u mark on the small (micro USB) connector is facing the lens
side of the camera when inserted.
• If the camera is on, hold down [
before connecting to the computer.
[USB] port
Micro USB cable
(included with camera)
] (Power) for about two seconds to turn it off
14
Computer
(power turned on)
USB
USB port
2
,
).
Quick Start Basics
Advertisement
Table of Contents
