Setting dialing method
The signaling method of your telephone must be set to
DTMF (dual-tone multifrequency signaling) or DP (dial puls-
ing) (depending on the dialing method of the telecommunica-
tion station) before you put your telephone into operation.
When delivered, your telephone is set for dual-tone multi-
frequency signaling.
Check: Dial any digit. If you hear the dial tone, you must
change over to the other dialing method.
Set:
Pushbutton on base of telephone:
T
P
Temporary changeover with
– only if tone/pulse switch is set to "P" –
Once a connection has been set up, you can switch to dual-
tone multifrequency signaling by pressing
ate an answering machine).
The telephone automatically reverts to dial pulsing once the
connection has been cleared down.
Setting the volume of tone ringing
1
2
3
Last number redial
You can redial the last number dialed by lifting the handset
and pressing the REDIAL key
Note:
The memory is cleared if the number entered contains more
than 32 digits.
Saved number redial
Storing
The number dialed can be stored while a call is in progress
by pressing the MEMO key M
stored even if other calls are subsequently made.
Dialing
Lift the handset and press M
Note:
A number remains stored until a new number is stored with
the MEMO key M
T for DTMF
P for DP
Pushbutton on base of telephone:
There are three optional levels:
1 = min. vol. 2 = normal vol. 3 = max. vol.
.
.
. This number is remains
.
5
(e.g. to oper-