Configurable Logging And Display Of Signal States - Siemens SICAM CMIC User Manual

Engineering via SICAM WEB
After selection of the category you can set the process-technical parameters for the respective
signals.
· Activate the checkbox Show all parameters if you want to edit expert parameters
·
Save your changes from time to time, refer to
Further steps:Restart

5.1.9.2.1 Configurable Logging and Display of Signal States

Process signals assigned to the master module can be configured for the logging (alarm list,
event list) and for the process display on the LCD (cockpit).
The following categories and signal types are designated for that:
Category
Process control
Process value analog
Process value digital
This is how to define signals for the logging and/or for the display on the LCD:
Example: Process control
· Under the tab Parameter, select the category "Process control"
All signals assigned to that categorie are displayed.
·
Select which signals are to be logged as an event
·
Enter the texts for names and states for the desired signals
Description of the parameters see
172
device.
TI Alarm list
TI 30
TI 31
TI 34
TI 35
TI 36
ü
TI 45
ü
TI 46
Process control.
Apply
Event list Cockpit
ü
ü
ü
ü
ü
ü ü
ü ü
SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016