Table of Contents
Advertisement
Chapter 3
ATX Power Supply Connector
Pow er on procedures
STEP
Description
After all connections are made, close the system case
1
over.
2
Be sure that all switches are off.
Connect the power cord into the power suppply located
3
on the back of your system case.
Connect the power cord a power outlet that is equipped
4
w ith a surge protector.
Many of the power supply support 110V/220V by a
5
switch setting. Switch your power supply to the correct
supply voltage.
Turn on your system in the following order
a. The monitor
6
b. The external devices.
c. The computer system.
The power LED on the front panel of the chassis will
light. After few seconds, the system will then run power-
on tests. Some additional messages will appear on the
screen during the test. If you do not see anything within
30 seconds from the time you turn on the power, the
system may have failed a power-on test. Recheck the
jumper settings and connections or call your retailer for
assistance.
18
Hardware Setup
Advertisement
Table of Contents
