Throttle Fail Safe Function; Abs Function; Model Data Copy (Copy) - FUTABA 3pv-2.4g Instruction Manual

This function moves the throttle servo to a preset position when the receiver cannot
receive the signal from the transmitter for some reason.
When the signal from the transmitter can be received again, this function automatically
resets.
*For gasoline engine cars, it is recommended that the fail safe position be set to the direction that
applies the brakes.
Battery F/S position setting (Only T-FHSS)
F/S position setting
Push the － （Minus) key while
operating the throttle trigger
to the desired position.
Setting example: Throttle
idle or brake position
This function simulates a full size
car's antilock braking by pulsing
the brake on and off rapidly. Model
stops as rapidly as possible without
skidding.
•The cycle speed can be selected from FST/
MID/SLW.
The contents of the currently selected model data can be copied to another model.
Selection of copy model data
The top (current
model) is chosen
with the steering.
The bottom (desti-
nation model) is
chosen with the
steering.
22
Throttle Fail Safe （ F/S ）
OFF: Inhibited
3.8V-7.4V
It depends on your
receiver battery.
Push the － key
Throttle trigger to
the desired position
Model Data Copy （ COPY ）
Select the
current model
numder with the
(+) or (-) key.
Select the
destination
model numder
with the (+) or (-)
key.
Voltage change
※ S-FHSS → Only 3.8V(Not change)
Key
FHSS → Not battery F/S function
Push the ＋ key → F/S OFF
ABS

ABS function

ABS Cycle Speed
OFF: Inhibited
FST: Active (fast)
MID: Active (middle)
SLW: Active (slow)
Model copy execution
Move (right or left)
the DT1 about 1
second.
Copying
Example
NiCd/NiMH 4 cell→3.8V
NiCd/NiMH 6 cell→4.4V
LiFe 2 cell→4.8V
LiPo 2 cell→5.6V
F/S Position
Throttle idle or brake
position
ABS change
Model copy complete