Table of Contents
Advertisement
9) Lay the flaps of the headrest mate-
rial down into the recess and in-
sert the Mounting Tray into the re-
cess. Check for fit. If it does not fit
properly, you may need to remove
some more foam.
NOTE: The Mounting Tray will need to
be secured to the headrest, either
by using tie straps, screws, etc...
10) Guide the cable through the side
opening of the Mounting Tray and
plug it into the Monitor. Make sure
the connector locks into place.
Insert the Monitor into the Mount-
ing Tray and secure the cable
using tie wraps or screws
11) Turn the Monitor around and in-
sert it into the Mounting Tray hous-
ing. Snap into place.
12) Connect the Monitor's DIN Cable
to the external video source out-
put signal (from VCP/DVD, TV
Etc.)Test the system to verify
proper installation.
7
Advertisement
Table of Contents
