Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Audiovox Movies 2 Go MMSV58
Summary of Contents for Audiovox Movies 2 Go MMSV58
-
Page 1: Installation Guide
MMSV58 5.8" LCD SUN VISOR MONITOR WITH MIRROR AND DOME LIGHT Installation Guide... - Page 2 An LCD display and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD display or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD display or video monitor is used for television reception, video or DVD play, the LCD display or video monitor must be installed so that these features will only function when the vehicle is in ‘park’...
-
Page 3: Materials Included In This Package
MATERIALS INCLUDED IN THIS PACKAGE: MMSV58 Sun Visor Video Monitor (P/N 136-3781) (1 pc) Monitor Mounting Shroud (P/N 1024053) (1pc) Remote Control (P/N 136-B3696) (1pc) Hardware Package:- • M2.5 x # 8” Screws (4 pcs) • Rubber Screw Plug Caps ((138-1324) (4 pcs) -
Page 4: Installation Notes
• NOTE: Each vehicle is different. Your specific disassembly and reassembly may vary slightly from the installation guide shown. INSTALLING THE MMSV58 1. Remove the Sun Visor from the vehicle. With Illuminated Vanity Mirror • Remove visor attaching hardware (screw) and set aside for re-assembly. - Page 5 2. Remove all accessories from the visor such as mirror/door/light assemblies, etc (if applicable) and set aside for re-assembly. Figure 3. Sun Visor With All Accessories Removed 3. Once all accessories are removed, check the dimensions and material depth of the sun visor to estimate the fit for your application.
- Page 6 NOTE: When using glue or double side tape, make sure to use only high temperature rated products that can handle the extreme temperatures of the vehicles interior 9. Plug the power power/signal harness into the rear of the MMSV58.
- Page 7 Figure 7. Installing The Monitor Shroud 10. Snap the screen into the visor mounting shroud Screw the screen to the visor mounting shroud using the 4 screws (supplied). 11. Install the 4 screw caps (supplied) in the holes on the 4 corners of the assembly. Figure 8.
- Page 8 WIRING GROUND ACTIVATED Figure 9. Power/Signal Harness Emergency MMSV58 Brake Switch Power Source Vehicle Ground Video Source VCP (VIDEO 1) DVD (VIDEO 2) Figure 10. Typical System Installation...
-
Page 9: Troubleshooting
TROUBLESHOOTING Symptom: No power at Video Monitor Power but no video or sound No Infrared Remote Functions Remedy: -Verify +12 VDC on Red wire at 7 pin Harness behind video monitor. Verify ground connection with continuity test from known good ground to black wire at 7 pin Harness -Verify that the correct source is selected (i.e.: 1,2,3 or 4). - Page 10 © Copyright 2004 AEC 150 Marcus Blvd. Hauppauge, NY 11788 128-7158...