Audiovox MM530 Owner's Manual page 6

5) Using the utility knife, cut the
headrest material along the "X"
lines. Do not cut the material
along the other lines at this
time.
6) This will leave you with an "X" cut
as shown.
7) Pull the flaps up and cut the foam
beneath the material to the
proper depth. Cut all four sides
of the foam.
8) Using your fingers, tear the foam
out of the headrest leaving a
recess where the shell will be
inserted.
NOTE: At this point you will need to
install the harness up through the
area into the recess. It may be help-
ful to follow one of the posts and tie
wrap it to the post for restraint.
6