17
Continued
Additional Receiver(s)
If you connected multiple receivers, follow these
steps to run a Check Switch test on each
additional receiver (one at a time), unless it is a
preconfigured DISH receiver. When you are done,
reconnect the receivers as before.
a. Temporarily disconnect the primary receiver
from the antenna's "RF1" cable.
b. Connect the additional receiver to the
antenna's "RF1" cable.
c. Perform Steps a-e on page 26 to run a single
Check Switch test on the receiver.
d. Wait 15 minutes, then verify the values on the
TV match the values shown in Figure 42 on
page 26. If your values do not match, try
running another Check Switch test.
Run a Check Switch Test
27