Toshiba VF-S15 Instruction Manual page 41


Operate in areas where ambient temperature ranges from -10°C to 60°C.
When using the inverter in locations with temperatures above 40°C, remove the protective label on the
top of the inverter and use the inverter with the output current reduced according to section 6.18.
Note: The inverter is a heat-emitting body. Make sure proper space and ventilation is provided when
installing in the cabinet.

Do not install in any location that is subject to large amounts of vibration.

If the inverter is installed near any of the equipment listed below, provide measures to insure against
errors in operation.

Do not install in any location of high temperature, high humidity,
moisture condensation and freezing and avoid locations where
there is exposure to water and/or where there may be large
amounts of dust, metallic fragments and oil mist.

Do not install in any location where corrosive gases or grinding
fluids are present.
[Position for measuring ambient temperature]
3cm
3cm
Measurement position
5cm
Measurement position
Note: If the inverter is installed in a location that is subject to
vibration, anti-vibration measures are required. Please
consult with Toshiba about these measures.
Solenoids:
Brakes:
Magnetic contactors: Attach surge suppressor on coil.
Fluorescent lights:
Resistors:
Resistors
A-29
E6581611
Attach surge suppressor on coil.
Attach surge suppressor on coil.
Attach surge suppressor on coil.
Place far away from the inverter.
1