Assembly; Operation; Unpacking; Packing List - Ryobi RLT26CDY User Manual

EN
FR DE ES IT
11. Safety Guard
12. Bump Head
13. Cutting Line
14. Idle Speed Screw
15. Spool retainer
16. Bolt
17. Wing nuts
18. Flat washer
19. Wrench
20. Paper tube
21. Hex nut

ASSEMBLY

Please refer to Fig. 2.

UNPACKING

This product requires assembly.
1. Carefully remove the tool and any accessories
from the box. Make sure that all items listed in the
packing list are included.
2. Inspect the tool carefully to make sure no breakage
or damage occurred during shipping.
3. Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
tool.
4. If any parts are damaged or missing, do not operate
this tool until the parts are replaced. Failure to heed
this warning could result in serious personal injury.

Packing list

Trimmer
Front handle assembly
Safety guard assembly
Bump head assembly
Wrench (2 types)
Operator's manual
Figure sheet
Engine oil
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
PT NL SV DA NO FI
English (Original instructions)
HU CS RU RO PL SL
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
ATTACHING THE FRONT HANDLE (FIG. 2a)
1. Remove the bolt, flat washer, and wing nut from the
front handle.
2. Install the front handle onto the upper end of the
power head (upper) shaft.
3. Replace the bolt, flat washer, and wing nut. Tighten
the wing nut.
ATTACHING THE DEFLECTOR (FIG. 2b)
1. Loosen the lock nut.
2. Insert the shaft into the deflector.
3. Tighten the lock nut.
INSTALLING THE BUMP HEAD (FIG. 2c)
1. Remove the paper tube.
2. Place the bump head on the drive connector.
3. Install the spool retainer and turn to lock.
4. Remove the plastic wrap.
5. Slide the protruding line into the slots. Pull the line
out to take up any slack.

OPERATION

WARNING
Read the operation manual and follow all
warnings and safety instructions.
WARNING
Wear eye protection and ear protection.
WARNING
Keep all bystanders, especially children and pets,
at least 15 m from the operating area.
FUEL AND REFUELING
HANDLING THE FUEL SAFELY
Always handle fuel with care, it is highly flammable.
Always refuel outdoors where there are no sparks
and flames. Do not inhale fuel vapors.
Do not let petrol or oil come in contact with your skin.
Keep petrol and oil away from the eyes. If petrol
or oil comes in contact with the eyes, wash them
immediately with clean water. If irritation is still
present, see a doctor immediately.
Clean up spilled petrol immediately.
15
HR ET LT LV SK BG