Yamaha DCD1+PS Operation Manual page 27

Note: <Connecting to a MX100 Series piano or an
earlier Disklavier Grand piano>
Normally, when no action is sent to the piano
for more than five minutes, the power supply
to the unit shuts off. In this case, pressing the
[STOP] button enables playback.
When connected to the DCD1+PS properly,
the piano's drive unit is always powered on, as
the DCD1+PS constantly sends MIDI data
(Active Sense Data) to the piano. If the
DCD1+PS is off or is not connected to your
piano, or if it was connected to your piano
more than five minutes after you turned on
your piano, you must press the [STOP] button
to enable operations.
Mark II Series, MPX100II
Make the following settings on
your piano.
Refer to your piano's owner's manual for
details.
MIDI IN CH ----------
MIDI IN ---------------
These settings are remembered when your
piano is turned off.
Mark III Series, Mark II XG
Series, Disklavier GranTouch,
MPX70, Pro
Make the following settings on
your piano.
Refer to your piano's owner's manual for
details.
Piano Rcv CH --------
DELAY IN ------------
HOST SELECT ------
(the HOST SELECT switch is on the rear
panel of the Control Unit.)
These settings are remembered when your
piano is turned off.
DSR1
Other Digital Pianos
Set your piano to receive channel 1 (piano part)
from the DCD1+PS.
Refer to your piano's owner's manual for details.
HP
DELAY IN
HP
ON
MIDI
Make the following settings on
your DSR1.
Refer to your owner's manual for details.
Piano Rcv Ch --------- HP
HOST SELECT ------ MIDI
(The HOST SELECT switch is on the rear
panel of the Control Unit.)
21