Care And Cleaning - Vita-Mix 7500 Owner's Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Container
To prepare your new machine for initial use, follow the procedure below. This will clean the unit and break in the motor.
Before using the Variable Speed option, always begin with the Variable Speed Dial pointing to the Stop Symbol ( ) at the top of the dial.
1.
Fill the container half full of warm water and add a few drops of liquid dishsoap to the container.
2.
Snap or push the complete 2-part lid into the locked position.
3.
Perform one of the following procedures:
Variable Speed:
a.
Rotate the Variable Speed dial to 1.
b.
Press the Start / Stop switch.
c.
Slowly increase variable speed to 10.
d.
Run the machine for 30 to 60 seconds.
e.
Rotate the Variable Speed dial to the Stop Symbol ( ) at the
top of the Variable Speed dial.
Program (Pro-750 only)
a.
Rotate the Variable Speed dial to the Cleaning ( ) program symbol. The program will stop automatically when complete.
b.
After the program stops, rotate the Variable Speed dial to the Stop Symbol ( ) at the top of the Variable Speed dial.
4.
Rinse and drain the container.
Lid, Lid Cap and Tamper
Separate the lid and lid cap. Wash parts in warm, soapy water. Rinse clean under running water and dry. Reassemble before use.
IMPORTANT: To ensure continued and effective performance, do not put the container, lid, lid cap or tamper in the dishwasher.
Motor Base
Electrical Shock Hazard.
Disconnect power before cleaning machine.
Failure to follow instructions can cause death or electrical shock.
1.
Unplug the power cord.
2.
Wash the outside surface with a damp soft cloth or sponge, which has been rinsed in a mild solution of liquid detergent and warm water. Do
not place the motor base in water.
3.
The centering pad can be removed for more thorough cleaning.
4.
Thoroughly clean the switches so they work freely. They may become sticky from use. Use a moistened cotton swab to clean the grooves
around the water-shielded switches. Immediately dry any excess water.
5.
Polish with a soft cloth.
8
C A R E A N D C L E A N I N G
WARNING

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro-300Pro-750Creations elite

Table of Contents