NOTE:
For a combo interface, the default operating port is the copper port. You can use either the copper port
•
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
HP HSR6800 Routers Interface Command Reference
see
Use transceiver modules for the fiber ports provided by HP only. The router might be incompatible with
•
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-600 combo interface specifications
Specification of combo interfaces on the FIP-600 and the FIP- 1 10 are the same. For more information,
see
Table 34
Transceiver modules for the FIP-600 and for the FIP- 1 10 fiber ports are the same. For more information,
see
Table
36.
Maximum interface modules provided by FIP-600 in full configuration
FIP/Interface
module
FIP-600
MIM
HIM
SAP-48GBE
SAP-48GBE front panel
Figure 96 SAP-48GBE front panel
(1) LEDs for GE ports 0 to 47
(3) GE ports 0 to 47
(5) Captive screw
SAP-48GBE specifications
Table 38 SAP-48GBE specifications
Item
Flash
and
Table
35.
HSR6802
2
Not supported
4
Remarks
4 MB
.
HSR6804
4
Not supported
8
(2) SAP module status LED (RUN)
(4) Ejector lever
103
HSR6808
8
Not supported
16