HP HSR6800 Installation Manual page 102

NOTE:
For a combo interface, the default operating port is the copper port. You can use either the copper port
•
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
HP HSR6800 Routers Interface Command Reference
see
Use transceiver modules for the fiber ports provided by HP only. The router might be incompatible with
•
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-110 combo interface specifications
Table 34 FIP-110 copper Ethernet port specifications
Item
Connector
Interface type
Supported frame format
Interface speed and
duplex mode
Table 35 FIP-110 fiber Ethernet port specifications
Item
Connector
Transceiver module type
Interface standards
Transmission
power
Receive sensitivity
Duplex mode
Table 36 Transceiver modules for the FIP-110 fiber ports
Model
SFP-GE-SX-MM85
0-A
Remarks
RJ-45
Autosensing
Ethernet_II
Ethernet_SNAP
10 Mbps
100 Mbps
1000 Mbps
Remarks
LC
SFP
802.3, 802.3u, and 802.3ab
Short-haul
Type multi-mode
(850 nm)
Minimum -9.5 dBm
Maximum 0 dBm
-17 dBm
1000 Mbps, full duplex
Central
Connector
wavelength
850 nm LC
.
Half/full duplex, auto-negotiation
Half/full duplex, auto-negotiation
Full duplex, auto-negotiation
Mid-haul
Long haul
single-mode
(1310 nm)
(1310 nm)
-9 dBm -2 dBm
-3 dBm 5 dBm
-20 dBm -23 dBm
Optical fiber
62.5/125 μm
multi-mode
optical fiber
96
Long haul
(1550 nm)
-4 dBm
1 dBm
-21 dBm
Transmission Max. transmission
rate distance
0.55 km (0.34
1250 Mbps
miles)
Super long
haul (1550
nm)
-4 dBm
2 dBm
-22 dBm