Basic Operation - Sharp PN-R556 Operation Manual

1
2
3
4
5
6
7
8
9
10
1. HDMI
Switch the input mode to HDMI1 or HDMI2.
2. Numeric input buttons
When HDMI CEC LINK is set to AUTO, use these buttons to
operate the device connected through the HDMI interface.
0 to 9 are also used in conjunction with the ID SET button.
3. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
4. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB →
HIGH ILLUMINANCE → STD...
• HIGH ILLUMINANCE is a display with colors suited to
bright locations.
• sRGB cannot be used when D-SUB[COMPONENT] is set.
sRGB is international standard of color representation
specified by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crystal's characteristics and represents color tone
close to its original image.
18
E

Basic Operation

5. VOLUME +/- (Volume adjustment)
Pressing + or - displays the VOLUME menu.
11
12
Press + or - to adjust the volume of the sound.
13
* If you do not press any buttons for about 4 seconds, the
6. INFORMATION
Displays monitor information.
INFORMATION1
INPUT MODE
SIZE
COLOR MODE
14
BRIGHT
VOLUME
ID No.
15
REMOTE No.
MODEL
16
VERSION
S/N
17
STATUS
LAN
18
1 9 2 0 x 1 0 8 0
19
INFORMATION2
20
RS-232C/LAN SELECT
DHCP CLIENT
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
MONITOR NAME
DATA PORT
MAC ADDRESS
LAN
1 9 2 0 x 1 0 8 0
The display changes from INFORMATION1 →
INFORMATION2 → INFORMATION3 → clear display, and so
on every time you press this button.
INFORMATION3 shows the information when you have used
the expansion slot to expand the functions.
• The display disappears automatically after about 15
•
• If
7. FUNCTION
Use this to display the FUNCTION menu. (See page 33.)
8. ENTER
Confirms the setting.
9. FREEZE
This is not used with the monitor.
10. Buttons for operating the HDMI-connected device
When HDMI CEC LINK is set to AUTO, use these buttons to
operate the device connected through the HDMI interface.
11. ID SET
Set a number on the remote control. (See page 32.)
V O L U M E 15
VOLUME menu automatically disappears.
01/01/2016 FRI 12:00:00 AM
: D-SUB[RGB]
: WIDE
: STD
: 31
: 15
: 0
: 0
: PN-R556
:
×.×.××.×
:
: 0000-000000-00-0000
V: 60 Hz H: 67.5 kHz
01/01/2016 FRI 12:00:00 AM
: LAN
: OFF
: 192.168.150.
: 255.255.255.
: 0. 0.
: PN-R556
: 10008
: XX-XX-XX-XX-XX-XX
V: 60 Hz H: 67.5 kHz
seconds.
is displayed during LAN communication.
LAN
is displayed in red, there is a duplicate IP address.
LAN
END:[RETURN]
2
0
0. 0
END:[RETURN]