HEIDENHAIN iTNC 530 User Manual page 192

Column Meaning
BLOCK Block number in which the TOOL CALL block
was programmed
TOKEN = TOOL: Path name of the active main
PATH
program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
T Tool number with tool index
Maximum feed rate override that occurred
OVRMAX
during machining. During test run, the TNC
enters the value 100 (%)
OVRMIN Minimum feed rate override that occurred
during machining. During test run, the TNC
enters the value -1
NAMEPROG 0: The tool number is programmed
1: The tool name is programmed
There are two ways to run a tool usage test for a pallet file:
The highlight is on a pallet entry in the pallet file:
The TNC runs the tool usage test for the entire pallet.
The highlight is on a program entry in the pallet file:
The TNC runs the tool usage test for the selected program.
192 Programming: Tools