Kyocera FS-1800 Service Manual page 160

Message
Memory overflow
Press GO
MemoryCard err##
Press GO
Paper path error
Print overrun
Press GO
: Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
Corrective action
The total amount of data received by the printer exceeds the printer's
internal memory. Try adding more memory (expansion DIMM). Press
the GO key to resume printing. You can abandon printing by the
CANCEL key. If Auto Continue is set to On, printing will be
automatically resumed after a preset period of time. Refer to printer's
User's Manual.
This message appears when an error occurred during access to the
memory card (CompactFlash) using the PRESCRIBE 2e RWER
command or from the printer's operator panel. Look at the error code
given in place of ## and refer to the corresponding description given
below:
01 : The memory card (CompactFlash) does not meet the requirement.
This memory card cannot be used by this printer. Insert a memory
card which complies with the requirements. (See section 1-1-2
Available option memory/device on page 1-6.)
02 : The memory card is not installed. Check the requirements for
using the memory card.
04 : The capacity of the memory card is insufficient. Clean up files.
05 : Specified file not found on the memory card.
06 : Insufficient printer memory to support a memory card. Expand
printer memory.
There is no cassette in the feeder, or the cassette is not inserted
properly. When two or more option feeders are installed and the lowest
one is selected, the same message will appear if any of the upper
feeder cassettes and the printer cassette is improperly installed.
The data transferred to the printer was too complex to print on a page.
Press the GO key to resume printing. (The page may break in some
pages.) You can abandon printing by the CANCEL key.
Note: After this message has been displayed, Page protect mode will
be On. To maintain optimum use of memory during printing, display
>Page protect from the operator panel, and re-select Auto. Refer
to printer's User's Manual.
If Auto Continue is set to On, printing will be automatically resumed
after a preset period of time. Refer to printer's User's Manual.
6-9
FS-1800/1800N | FS-3800/3800N